Mar 05, 2011 · White iron Mild steel backing Cut notch min. 3mm. deep Forming procedure Note:for severe curves with a radius of less than 305mm. or inside curves, it is advisable to notch the mild steel backing plate opposite the V to assist forming fig. 1 1. Clean the surface to armox advance high hardness protective steel plate seller ARMOX ADVANCE - oblibene armox advance high hardness protective steel plate sellerSSABs toughest, ultra-hard protection plate Armox® Advance is SSABs toughest appliqué (add-on) protection plate for use where component weight reduction is essential. It is available in thicknesses between 4.0 and 7.9 mm, and not intended for further heat treatment.